Step 1: Cleaning chemicals
Go to supply room and find the plastic container and the pipeline soap.
Step 2: Mixing
Fill the container with soap up to the bottom line.
Fill up the rest with hot water.
Step 3: Attaching the pipes
Attach the pipe from the fustage to the container, screwing it on and off like on the fustage.
Make sure to press the handle down so that the gas runs through the container.
Step 4: Let it sit
Turn on the tap and let the beer run out until the beer changes to purple water.
Then stop the stream and let sit for 15 minutes.
After letting the soapwater sit in the pipes for 15 minutes, turn on the tap again and let all the soap water run out.
Step 5: Rinse
Now rinse the container and refill with hot water only.
Before screwing of the top lid of the container, you need to pull on the black knob on the side, to let out the gas.
Let it run through the pipes to clean of soap. Repeat once.
Step 6: Resetting
Reattach the pipes to the right fustage and run the tap until the beer comes through the tap.
!OBS!
- Remember to note down the amount of beer wasted.
- If the soap or does not run, check the carbontank to see if it needs changing.